PAS 68 High Impact Security Sliding Gates
Avon SG1500CR High Impact Sliding Armoured Vehicle Gates provide a high level of security against unauthorised vehicle access and are designed as a Hostile Vehicle Mitigation Solutions (HVM).
The SG1500CR gate was first independently physically tested by the Transport Research Laboratory (TRL) using an N3 European Truck in accordance with the PAS 68 specification (7,500kg weighted vehicle travelling at 80kph) and post test achieved zero penetration. The same gate was then crash tested with a 4x4 pick up truck travelling at 80 kph and zero penetration was achieved.
The gate design was then aesthetically enhanced by removing the front two support legs and independently tested by the Transport Research Laboratory (TRL) with a US truck (15,000lb truck at travelling at 50 mph) in accordance with the US Standard ASTM F 2656-07 ( supersedes DoS SD-STD-02.01 ) again the gate stopped the vehicle and zero penetration was achieved.
Both the PAS 68 & ASTM F2656-07 versions of the crash tested sliding vehicle armoured gates are designed to withstand substantial direct impact forces and protect sites from extreme aggressive hostile vehicle attacks and are highly dependable security products.
SG1500CR High Impact Gates are developed and manufactured by engineers with significant experience in the fields of High Security and Access Control.
SG1500CR Gates are armoured vehicle gates incorporating a full impact resistant system which enables a wide range of gate heights, clear widths and infill to be provided. Both versions of the Sliding Gates foundation depths are from under 500mm subject to gate design.
Automatic high security sliding gates come with a hold to run control as standard, however they can be customised to interface with a wide range of access control equipment to suit specific customer requirements (available as options) and any configuration including (but not limited to) inductive loop systems, card readers, communication equipment and manned guard panic systems can be accommodated.
Where the High Security Gates control point is remote from the installation, we strongly recommend the fitting of a recordable CCTV system, traffic lights and safety inductive loop systems.
Please note that a full site risk assessment must be carried out at design stage to ensure all relevant safety systems are included as this is a specialist high security product and is designed for use with vehicles only.
View our other High Security PAS68 Crash Tested products
|High Impact High Security Sliding Gates|
|PAS68 High Impact Hinged Security Gates|
|PAS68 High Security Barriers|
|PAS68 Security Road Blockers|
|PAS68 High Security Shallow Roadblockers|
|PAS68 High Security Surface Road Blockers|
|PAS68 High Security Bollards|